EDID Mode Selection Commands
Extended Display Identification Data (EDID) is a data format that contains a display's basic information and is used to communicate with the video source/system. You can set which EDID mode the VM0404H uses with the following command:
EDID Command + Control + [Enter]
For example, to pass the EDID from Port 1 to all sources, type the following:
edid port1 [Enter]
The following tables show the possible values for commands:
Command | Control | Description |
|
|
|
edid | port1 | The EDID from Port 1 will be passed to all video |
|
| sources |
|
|
|
edid | remix | Implement the EDID of all connected displays. The |
|
| VM0404H uses the best common resolution |
|
| applicable for all displays |
|
|
|
edid | default | Implement default EDID for all (default) |
|
|
|
Reset Commands
The formula for Reset commands is as follows:
Reset Command + [Enter]
For example, to reset the device back to the default factory settings, type the following:
reset [Enter]
The following table shows the possible values for commands:
Command | Description |
|
|
reset | Reset device back to factory default settings |
|
|
Verification
After entering a command, a verification message appears at the end of the command line as follows:
Command OK - indicates that the command is correct and successfully performed by the switch
Command incorrect - indicates that the command has the wrong format and/or values
- 19 -