ATEN Technology VS1814T, VS1818T manual Rear View

Chapter 1. Introduction

Rear View

1	2	3 4	5		6	7 8	9
No.		Component		Function
1	Power Socket		This is a standard 3-pin AC power socket. The
			power cord from an AC source plugs in here.
2	Power Switch		This is a standard rocker switch that powers the unit
			on and off.
3	Grounding Terminal		The grounding wire attaches here. See Grounding,
			page 9, for further details.
4	EDID Mode Switch		Press this button to cycle through the EDID settings
			stored in the unit (see EDID Mode Selection,
			page 12).
5	HDBaseT Out ports		The Cat 5e cables that connects the HDMI Receiver
	(1~4 / 1~8)		Units plug in here.
6	HDMI Input port		The cable from your HDMI source device plugs in
			here.
7	HDMI Output port		The cable from your HDMI display device plugs in
			here.
8	Firmware		This button is for enabling the Firmware Upgrade
	Upgrade button		Mode.
			Note: Contact your product provider for details on
			upgrading the firmware of your device.
7	RS-232 Serial Port		This is the serial remote port for output source
			selection and high-end system control, including
			firmware upgrade.

Note: The VS1818T’s rear panel is shown on this page. It is similar to the rear panel of VS1814T except for the number of HDBaseT Out ports – the VS1814T has 4 HDBaseT Out ports.

5