Athena Technologies 16C instruction manual JMPØ2

Input Menu

Input Menu (continued)		Input Jumper Settings
Display Parameter	Selection
Input Type	100 ohm
	compressed RTD
	0-20 mA
	4-20 mA
	0-10 mV
	0-50 mV
	0-100 mV
	10-50 mV
	0-1 V	Input Type	JMPØ1 JMPØ2
	0-5 V	Thermocouple	Out	Out
JMPØ2	0-10 V
		RTD	Out	Out
	1-5 V
		Voltage <100 mV	Out	Out
		Voltage >100 mV	In	Out
		Current Process	In	In

Note: When you ordered your controller, an input type was specified and the controller was set up accordingly and calibrated for that input type at the factory. If you decide to change input type from

thermocouple to RTD or vice-versa, you will need to recalibrate the controller unless you ordered the

JMPØ1

“Calibrate All” option. (Refer to page 56 for information on recalibration.) If you are changing from a temperature input type to a linear input type, you MUST recalibrate and change the jumper settings as indicated in the above table.

Input Menu

Temperature Input Type

Display Parameter	Selection
Bias (Display offset)	-100 to 100
Lower Setpoint Limit	Span of Sensor
Upper Setpoint Limit	Span of Sensor
Filtering	0.1-10.0 sec.

Linear Input Type

Display Parameter	Selection
Bias (Display offset)	-100 to 100
Low Scale	-1999 to 9999
High Scale	-1999 to 9999
Lower Setpoint Limit	Span of Sensor
Upper Setpoint Limit	Span of Sensor
Filtering	0.1-10.0 sec.

16