Installing an Fpim | Cabletron Systems 9F106-01 manual

Installing the MMAC-Plus Module

Installing an FPIM

The 9F106-01 module is shipped without FPIMs. To install an FPIM, follow the procedure below:

1.Remove the module if it is installed in the MMAC-Plus chassis.

2.Remove the blank front cover over the FPIM slot.

3.Install the FPIM as shown in Figure 2-4.Ensure that the rear connector is seated ﬁrmly before tightening the two mounting screws.

Figure 2-4. Installing an FPIM

2-6

Image 15

Cabletron Systems 9F106-01 manual Installing an Fpim

Contents

MMAC-Plus9F106-01 Two Port Fddi Router User’s Guide Page Vcci Notice FCC Notice DOC Notice Contents Introduction Features Management Information Base MIB Support Features Getting Help Related Manuals Installing the MMAC-Plus Module Installing the MMAC-Plus Module Local Management Console Reset Switch Xoff Menu Function Selection Local Management Console Installing an Fpim Installing an Fpim Operation F106-01 Block Diagram DC/DC Converter System Diagnostic ControllerFlexible Network Bus FNB System Management Buses CPU FNB Interface Lanview LEDs Lanview LEDs LED Color State LED Color State Description Function of the Fddi Receive LED is listed in Table Safety ServiceSpeciﬁcations Environment Physical Parameter Typical Value Worst Worst Case Budget Fpim Speciﬁcations Pin Number Represents FPIM-02 and FPIM-04 Parameter Typical Minimum Maximum FPIM-05