FPIM-05 | Cabletron Systems 9F106-01 instruction

FPIM-05

FPIM-05

The FPIM-05 has a MIC style connector supporting a Single-mode ﬁber connection. The speciﬁcations are listed in Table A-4.

Table A-4. FPIM-05 Speciﬁcations

Parameter	Typical	Minimum	Maximum


Transmitter Peak Wave	1300 nm	1270 nm	1330 nm
Length

Spectral Width	60 nm	-	100 nm

Rise Time	3.0 nsec	2.7 nsec	5.0 nsec

Fall Time	2.5 nsec	2.2 nsec	5.0 nsec

Duty Cycle	50.1%	49.6%	50.7%

Bit Error Rate	Better than 10-10

The link distance is up to 40 kilometers (max) and 25 kilometers (typical) on single mode ﬁber-optic cable as speciﬁed by ANSI SMF-PMD.

A-3

Image 26

Cabletron Systems 9F106-01 manual FPIM-05, Parameter Typical Minimum Maximum

Contents

MMAC-Plus9F106-01 Two Port Fddi Router User’s Guide Page FCC Notice Vcci Notice DOC Notice Contents Features Introduction Management Information Base MIB Support Features Related Manuals Getting Help Installing the MMAC-Plus Module Installing the MMAC-Plus Module Reset Switch Local Management Console Menu Function Selection Xoff Local Management Console Installing an Fpim Installing an Fpim F106-01 Block Diagram Operation System Management Buses System Diagnostic ControllerFlexible Network Bus FNB DC/DC Converter FNB Interface CPU Lanview LEDs Lanview LEDs LED Color State Description LED Color State Function of the Fddi Receive LED is listed in Table Speciﬁcations SafetyService Physical Environment Fpim Speciﬁcations Parameter Typical Value Worst Worst Case Budget FPIM-02 and FPIM-04 Pin Number Represents FPIM-05 Parameter Typical Minimum Maximum