Installing the MMAC-Plus Module | Cabletron Systems 9F106-01

Installing the MMAC-Plus Module

Plastic Tabs

Jack for ESD wrist strap

Metal Back-Panel

Circuit Card

Card Guides

Warning:

Ensure that the circuit card is between the card guides.

Lock down the top and bottom plastic tabs at the same time, applying even pressure.

Figure 2-1. Installing the MMAC-Plus Module

2-2

Image 11

Cabletron Systems 9F106-01 manual Installing the MMAC-Plus Module

Contents

MMAC-Plus9F106-01 Two Port Fddi Router User’s Guide Page Vcci Notice FCC Notice DOC Notice Contents Introduction Features Management Information Base MIB Support Features Getting Help Related Manuals Installing the MMAC-Plus Module Installing the MMAC-Plus Module Local Management Console Reset Switch Xoff Menu Function Selection Local Management Console Installing an Fpim Installing an Fpim Operation F106-01 Block Diagram DC/DC Converter System Diagnostic ControllerFlexible Network Bus FNB System Management Buses CPU FNB Interface Lanview LEDs Lanview LEDs LED Color State LED Color State Description Function of the Fddi Receive LED is listed in Table Speciﬁcations SafetyService Environment Physical Parameter Typical Value Worst Worst Case Budget Fpim Speciﬁcations Pin Number Represents FPIM-02 and FPIM-04 Parameter Typical Minimum Maximum FPIM-05