Fpim Speciﬁcations | Cabletron Systems 9F106-01 guide

Appendix A

FPIM Speciﬁcations

This MMAC-Plus module uses Fiber Port Interface Modules (FPIM) to provide front panel cable connections. The FPIMs are user-installable. See the section titled Installing an FPIM on page 2-6.

FPIM-00

The FPIM-00 has a MIC style connector supporting a multimode ﬁber connection. The speciﬁcations are listed in Table A-1.

Table A-1. FPIM-00 Speciﬁcations

	Parameter	Typical Value	Worst	Worst Case	Typical
	Parameter	Typical Value	Case	Budget	Budget
			Case	Budget	Budget


	Receive	-30.5 dBm	-28.0 dBm	—	—
	Sensitivity

	Peak Input	-7.6 dBm	-8.2 dBm	—	—
	Power

A-1

Image 24

Cabletron Systems 9F106-01 manual Fpim Speciﬁcations, Parameter Typical Value Worst Worst Case Budget

Contents

MMAC-Plus9F106-01 Two Port Fddi Router User’s Guide Page FCC Notice Vcci Notice DOC Notice Contents Features Introduction Management Information Base MIB Support Features Related Manuals Getting Help Installing the MMAC-Plus Module Installing the MMAC-Plus Module Reset Switch Local Management Console Menu Function Selection Xoff Local Management Console Installing an Fpim Installing an Fpim F106-01 Block Diagram Operation System Diagnostic Controller Flexible Network Bus FNBSystem Management Buses DC/DC Converter FNB Interface CPU Lanview LEDs Lanview LEDs LED Color State Description LED Color State Function of the Fddi Receive LED is listed in Table Safety ServiceSpeciﬁcations Physical Environment Fpim Speciﬁcations Parameter Typical Value Worst Worst Case Budget FPIM-02 and FPIM-04 Pin Number Represents FPIM-05 Parameter Typical Minimum Maximum