Cabletron Systems 9F106-01 manual The Reset Switch, Local Management Console

The Reset Switch

The Reset Switch

The Reset switch is located on the front panel, under the top plastic tab, as shown in Figure 2-2.It serves two functions:

•Pressing the Reset switch twice within three seconds causes the processor to reset.

•Pressing and holding the switch on for three or more seconds causes the module to shutdown. Pressing and holding again for three seconds restarts the module.

SNMP management may be used to disable this switch to enhance module security.

Reset Switch

Figure 2-2. The Reset Switch

Local Management Console

Local Management is accessed by attaching a management console at the RJ-45 CON port of the 9F106-01. The console connection supports a Digital Equipment Corporation VT 320™ terminal or PC emulation of one of these terminals.

Table 2-1lists the setup requirements for the local management console. If your terminal is a Digital Equipment Corporation VT 320™ terminal, press F3 to access the Setup Directory. If you have a terminal emulation of the Digital Equipment terminals, refer to your equipment user manual for setup procedures.

2-3