Athena Technologies 6050 instruction manual General

3.Loss of power or turn-off during warm-up requires a re-start from ambient.

4.Change of state processes, i.e. solid to liquid or

liquid to gas, may introduce erroneous tuning parameters during process warm-up.

GENERAL

1.Accurately measures, linearizes and displays temperature in °F and °C.

2.Automatically calculates and displays parameters-heat gain, and rate/reset time.

3.Can be field converted from relay output "B", to solid state relay “T", to solid state driver "S" or to

a 4-20 MA output SCR driver "F".

4.Will remember its "entered" settings after power failure or shut-off and not "Go To Sleep".

CAUTION: HIGH VOLTAGE AN0 HIGH TEMPERATURES CAN CAUSE INJURY AN0 ARE A FIRE HAZARO. PLEASE REAO ALL INSTRUCTIONS, HAVE ONLY SKILLED PROFESSIONALS WIRE THE UNIT, AND USE APPROVED TEMPERATURE AND/OR PRESSURE SAFETY CONTROL. EVEN THE BEST COMPONENTS CAN BE DAMAGED OR MAY NOT FAIL SAFE.

CONFIGURATION

Depending on the model number of the unit you have ordered, vou will find one of four basic modules installed. The fifth digit of the code indicate the output module type.

B- Relay 7A/5A @ 120/240 Vac F - 4-20 mA (Proportional)

T - Triac 1 Amp @ 240 Vac

S - 20 VDC Pulsed for driving solid state relays

Example: 6050-F has proportional 4 to 20 mA heat output.

Note: If you have not received your controller from the factory direct, check to confirm that the correct module for your application is installed. Since the modules plug-in, and since controller plug into cases as well, previous users may have changed modules, which can result in severe controller damage.

5