Manuals / Brands / Lawn and Garden / Tiller / ATI Technologies / Lawn and Garden / Tiller

ATI Technologies 365 END OF SEASON STORAGE, SERVICE, SPECIFICATIONS, TIRES, FRAME, ENGINE, WEIGHT, DRIVES, CONTROLS, FUEL TANK, DIMENSIONS, TRANSMISSION, GROUND SPEED

1 29

Download 29 pages, 625.39 Kb

TRACTOR OPERATION

END OF SEASON STORAGE

SERVICE

CLEAN THE ENTIRE MACHINE AND ENGINE

Thoroughly clean the machine and engine then blow dry with 50 PSI compressed air.

ENGINE SERVICE

1.Refer to the engine manufactures manuals for specific recommendations and proce- dures.

MACHINE SERVICE

1.Lubricate all grease point as shown in the Lubrication Section.

2.Lubricate all linkage pivot points.

3.Spray exposed cabled with a fluid lubricant to prevent binding and rust.

4.Examine drive belt and chain for damage and replace as required.

5.Check the condition of all shields and replace as required.

6.Check safety decals and replace as required.

7.Check all bearings and gear box for bearing condition. Replace any loose bearings.

SPECIFICATIONS

ENGINE

Honda - GXV390K1 13.0 HP

FUEL TANK

1.0 US Gallon

TRANSMISSION

Tuff Torq Model K62 Hydrostatic

Infinite variable control

Oil - 2.5 liters of 10W30 Class CD motor oil

GROUND SPEED

0 - 4.2 mph

WEIGHT

440 Lbs.

DIMENSIONS

42" W x 45" H x 76" L

36" Maximum working width

DRIVES

Engine mounted clutch/brake

Heavy duty bevel gearbox with sealed bearings B76 main drive belt

#50 o-ring final drive chain

TIRES

Rear = 18 x 6.5 heavy 4-Ply lugged

CONTROLS

Variable speed control lever

Swing control lever

Transport release lever

FRAME

Heavy formed tube mainframe, Tractor 12 gauge fabricated mainframe, Tiller

12

Contents

Page Page DISCLAIMER FIGURE NUMBER PAGE NO SUBJECT Safety Precautions DANGER, WARNING, and CAUTION NOTE: THE BEST OPERATOR IS A CAREFUL OPERATOR SAFETY PRECAUTION DEFINITIONS avoided, will result in death or serious injury serious injury SAFETY DECALS Page TRACTOR SERIAL NUMBER LOCATION PRESEEDER SERIALNUMBER LOCATION ENGINE SERIAL NUMBER LOCATION Page DAILY CHECKS TO PERFORM BEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVEL CHECK FUEL LEVEL CHECK THAT ALL SHIELDS ARE INSTALLED AND ATTACHING HARDWARE IS TIGHT CHECK TIRE PRESSURES ENGINE OPERATION OPERATING THE TOW VALVE PARKING THE MACHINE OPERATING THE DIRECTIONAL CONTROLS ADJUSTING THE VARIABLE SPEED CONTROL (Cont’d) REVERSE DIRECTION FORWARD DIRECTION When stopping release the control lever slowly TRACTOR SWING CONTROL LEVER ANGLING THE ATTACHMENT USING THE SWING CONTROL LEVER END OF SEASON STORAGE SERVICE SPECIFICATIONS GENERAL SAFETY OPERATING THE ATTACHMENT OPERATION SECURING THE MACHINE FOR TRANSPORT DETACHING PRESEEDER TILLER FROM TRACTOR REVERSE ORDER FOR ATTACH ING PRESEEDER TILLER TO Worn grease fittings that will not hold the gun, and fittings with a stuck check ball, must be replaced EVERY 10 HOURS FILL POINT MAIN DRIVE BELT REMOVAL MAIN DRIVE BELT ADJUSTMENT DRIVE CHAIN REMOVAL DRIVE CHAIN ADJUSTMENT DRIVE CHAIN ADJUSTMENT (Cont’d) ROTOR TOOTH WEAR If tiller must be raised off the ground, block securely STANDARD TEETH CARBIDE TEETH Page SYMPTOM POTENTIAL CAUSE REMEDY authorized dealer IMPORTANT: