ATI Technologies 365 FOR TRANSPORT, DETACHING PRESEEDER TILLER, FROM TRACTOR, REVERSE ORDER FOR ATTACH, ING PRESEEDER TILLER TO, TRACTOR

PRESEEDER OPERATION

FOR TRANSPORT

1.Position the machine on a trailer or other vehicle (See Figure 27).

2.Stop the engine.

3.Lower the Preseeder until the rotor rests on the deck.

NOTE: The attachment must be fully lowered during transport or the frame may be damaged.

4.Use the front tie down loops on the bot- tom of the wheel frame to secure the front of the machine.

5.Secure the rear of the tractor using the tie down loops as shown

NOTE: Do not over tighten the tie down straps or the frame or tires may be dam- aged.

DETACHING PRESEEDER TILLER

FROM TRACTOR

1.Turn off Tractor engine and lower rotor to ground.

2.Remove Main Drive Belt Shield by removing 2(two) mounting bolts (See Figure 30 on Page 18 ).

3.Move Drive Belt Release Handle to the disengaged position, and remove belt from Drive Pulley (D) on engine (See Figures 31 & 32 on Page 18).

4.Remove 2(two) 1/2 inch attaching bolts (See Figure 28).

FIGURE 28 Attaching Bolts Preseeder to Tractor

REVERSE ORDER FOR ATTACH-

ING PRESEEDER TILLER TO

TRACTOR

FIGURE 27 Transport Tie Downs

16