ATI Technologies 365 SAFETY DECALS

SAFETY PRECAUTIONS

SAFETY DECALS

The safety decals appearing in Figure 1 are a sampling of those affixed to the tiller. These examples are not meant to represent all decals, but do illustrate typical precautionary and informational signage relating to tiller operation and use.

IMPORTANT: It is the responsibility of the operator to locate, read, and adhere to all information provided on all decals affixed to the unit being operated.

Contents

Page Page DISCLAIMER FIGURE NUMBER PAGE NO SUBJECT Safety Precautions DANGER, WARNING, and CAUTION NOTE: THE BEST OPERATOR IS A CAREFUL OPERATOR SAFETY PRECAUTION DEFINITIONS avoided, will result in death or serious injury serious injury SAFETY DECALS Page TRACTOR SERIAL NUMBER LOCATION PRESEEDER SERIALNUMBER LOCATION ENGINE SERIAL NUMBER LOCATION Page DAILY CHECKS TO PERFORM BEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVEL CHECK FUEL LEVEL CHECK THAT ALL SHIELDS ARE INSTALLED AND ATTACHING HARDWARE IS TIGHT CHECK TIRE PRESSURES ENGINE OPERATION OPERATING THE TOW VALVE PARKING THE MACHINE OPERATING THE DIRECTIONAL CONTROLS ADJUSTING THE VARIABLE SPEED CONTROL (Cont’d) REVERSE DIRECTION FORWARD DIRECTION When stopping release the control lever slowly TRACTOR SWING CONTROL LEVER ANGLING THE ATTACHMENT USING THE SWING CONTROL LEVER END OF SEASON STORAGE SERVICE SPECIFICATIONS GENERAL SAFETY OPERATING THE ATTACHMENT OPERATION SECURING THE MACHINE FOR TRANSPORT DETACHING PRESEEDER TILLER FROM TRACTOR REVERSE ORDER FOR ATTACH ING PRESEEDER TILLER TO Worn grease fittings that will not hold the gun, and fittings with a stuck check ball, must be replaced EVERY 10 HOURS FILL POINT MAIN DRIVE BELT REMOVAL MAIN DRIVE BELT ADJUSTMENT DRIVE CHAIN REMOVAL DRIVE CHAIN ADJUSTMENT DRIVE CHAIN ADJUSTMENT (Cont’d) ROTOR TOOTH WEAR If tiller must be raised off the ground, block securely STANDARD TEETH CARBIDE TEETH Page SYMPTOM POTENTIAL CAUSE REMEDY authorized dealer IMPORTANT: