OnePower Line Interactive UPS (EN)

the UPS. Connect from the “OUT” jack with telephone cable (supplied) or network cabling (not supplied) to a fax modem or network port.

Connect the supplied interface cable to the RS232 computer interface port on the back of the UPS. Connect to the computer. See software document for installation instruction.

1.7Operation Test

1.Connect the UPS to the wall receptacle.

2.With the UPS plugged in, press and hold the POWER button more than 3 seconds until hearing one short beep sound to switch the UPS on, then UPS is in the displaying condition. If use UPS for first time, please let UPS operate for 10 hours emptily to charge battery so that battery can't be in low capacity.

3.After switch on UPS, in utility power mode, press POWER button (within 2 seconds), and UPS perform a self-test on the battery capacity, renew within 3 seconds.

4.Connect your computer equipment with sockets of the UPS and pull off the input power cable of the UPS from the wall receptacle to check if the LED Battery is Orange. Meanwhile, please check if alarm buzzer is beeping(every 3-5 seconds).Check if the UPS is initiated properly to support continuous operation.

A03-PS651

Pag. 20