TROUBLESHOOTING GUIDE

If you experience a problem with your Light Control, first follow this guide. For additional assistance write to: Atlas Lighting Products, Inc. • Customer Service Department • P.O. Box 2348 • Burlington, NC 27216

SYMPTOM

POSSIBLE CAUSE

 

 

 

Light will

1.

Light switch is turned off.

not come

2.

Bulb is loose or burned out.

on.

3.

Fuse is blown or circuit breaker is

 

 

turned off.

 

4.

Daylight turnoff is in effect (Re-

 

 

check after dark).

 

5.

Incorrect circuit wiring, if this is a

 

 

new installation.

 

6.

Re-aim the sensor to cover de-

 

 

sired area.

Light comes

1.

Light Control may be installed in

on in

 

a relatively dark location.

daylight.

2.

Light Control is in Test. (Set control

 

 

switch to an ON-TIME position).

 

 

 

Light comes

1.

Light Control may be sensing

on for no

 

small animals or automobile traf-

apparent

 

fic (Re-aim sensor).

reason.

2.

Sensitivity is set too high. (Re-

 

 

duce sensitivity).

 

 

 

SYMPTOM

POSSIBLE CAUSE

 

 

 

Light stays on

1.

The sensor is pointed at nearby

continuously.

 

objects that cause heat to trigger

 

 

the sensor. (Aim the sensor

 

 

away from nearby objects).

 

2. The sensor is pointed toward a

 

 

heat source like an air vent,

 

 

dryer vent, or brightly-painted

 

 

heat-reflective surface. (Re-aim

 

 

sensor).

 

 

Light flashes

1. Heat being reflected from other

on and off.

 

objects may be affecting the

 

 

sensor. (Re-aim sensor).

 

2. Light Control is in the Test mode

 

 

and warming up. (Flashing is

 

 

normal under these conditions).

 

 

 

FIVE YEAR LIMITED WARRANTY

Atlas Lighting Products, Inc. warrants against defects in materials or workmanship for a period of five years from the date of purchase for use, and agrees to repair or, at our option, replace a defective unit without charge for either parts or labor. IMPORTANT: This warranty does not cover damage resulting from accident, misuse of abuse, lack of reasonable care, the affixing of any attachment not provided with product, alteration of any attachments factory installed, loss of parts or subjecting the fixture to any but the specified electrical service. This warranty does not cover failure of the bulb due to accidents, abuse, misuse, vandalism, power surges, and acts of nature such as lightning damage. No responsibility is assumed for any special incidental or consequential damages. Damages occurring during transit are not covered by this warranty-including UPS shipments. To obtain warranty service, mail sales receipt as proof-of-purchase, date and a brief explanation of the nature of the defect, to the address listed below. You will receive, by mail, a Return Goods Authorization number and full instructions for returning defective merchandise. All returned goods must be accompanied by a Return Goods Authorization number issued by Atlas Lighting Products, Inc.

NOTE: No other warranty, written or verbal, is authorized by Atlas Lighting Products, Inc. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above exclusion and limitations may not apply to you.

For information regarding replacement parts please write to:

Atlas Lighting Products, Inc.

Attn: Customer Service Department

P.O. Box 2348

Burlington, NC 27216

4

598-1095-01

Page 4
Image 4
Atlas PLMS manual Troubleshooting Guide, Five Year Limited Warranty