| INSTALLATION INSTRUCTIONS |
Kit Contains:
•(2) Rack Ears
•(4) Rack Ear Chassis Screws
•(1) Rack Extension Plate for Single Unit Mounting
•(2) Screws to Combine Extension Plate to Rack Ear
•(2) Nuts to Secure Screws to Extension Plate and Rack Ear
•(2) Bottom Joiner Plates
•(4) Bottom Joiner Plate Screws
•(4) Rack Rail Screws with Plastic Washers
Instructions:
Configuration #1 - Mounting two AA35 or PA601 amplifiers or one AA35 with a PA601
1.Disconnect amplifier from electrical source.
2.Remove the four feet from the bottom of each unit.
3.Align and secure the two joiner plates to the bottom of units with the enclosed screws. Note: Both plates must be attached, one towards the front and one towards the back.
4.Remove front two screws from the sides of the amps.
5.Align the enclosed rack ear to these chassis holes.
6.Use the enclosed chassis screws to attach the rack ears to either side of the amplifiers. Secure firmly, do not over tighten.
7.Install into rack using rack rail screws and washers provided.
8.Disregard any additional pieces.
PLAREAR
TE
FRO
PLATENT
Illustration 1: Rack Mounting Two Amplifiers
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800)
©2006 ATLAS SOUND LP | Printed in U.S.A. | 00406 | ATS002329 RevA 04/06 | PP |
