Panel Description
1 |
| 2 | 3 |
IR | - | + |
|
IR IN | IR OUT | HDMI OUT | |
PWR |
|
|
|
LINK |
|
|
|
|
|
| FW |
|
|
| |
4
5
6
1.IR IN Port: Connect the IR receiver to this port.*
2.IR OUT Port: Connect the IR Emitter to this port.*
3.HDMI OUT Port: Connect to HDMI display.
4.Yellow Link LED: Signal Indicator for the CAT5e/6/7 OUT port. LED will remain solid, unless there is an issue with the cable or signal, then it will blink.
Green Power LED: Power indicator. If plugged in light will remain solid. If LED starts blinking power is intermittent or there is a problem with the cable. If LED is off, no power is passing to the receiver (check your outlet or the power cable for the transmitter).
5.Firmware Update Port: Use a Mini USB to USB A cable to connect to a Windows computer for updating.
6.CAT5e/6/7 IN Port: Connect a category cable from a compatible transmitter to this port.
*For IR products only
Electrical Box
With so many electrical back boxes it is hard to know which to purchase with any wall plate. For convenience Atlona has compiled recommended electrical boxes to use with the
For 9.5mm up to 12.5mm walls: Red/Grey 1 Gang box or mud ring is best
For 12.5mm walls: Appleby 1 gang box or mud ring is best
Note: All electrical back boxes must be at least 30mm deep.
atlona.com | 4 | Toll free: |
Local: | ||
|
|
