
CAPTM CUSTOMIZABLE MICROCONTROLLERS
AT91CAP7X-DK Development Kit
for CAP Customizable Microcontroller
The
the application under development at close to operational speed, with no penalty for hardware modifications. This enables software development to proceed in parallel with hardware development, and significantly reduces the design cycle time, increasing confidence in a
The
AT91CAP7X-DK Motherboard
The
nATX power supply connector
n2x
n
nDBGU serial communication port
n4x analog inputs
nAC97 interface with three 3.5 mm audio jack connectors (MIC IN, LINE IN, LINE OUT)
nI2S audio codec with two 3.5 mm audio jack connectors (LINE IN, LINE OUT)
n2x SD/MMC card slots
nAtmel TWI serial EEPROM
n1/4 inch TFT LCD VGA interface
nTouch Screen Controller
nImage Sensor expansion connector
n16 push buttons arranged in a keypad form
nCAN bus interface
nSoftware controlled Power LED
n2x
nPIO expansion connectors (PIOA, PIOB, PIOC, PIOD)
nCAP Mezzanine extension connectors (2x 320 pins)
nPCI64 form FPGA I/O extension connector
nCustom
n3x USB device PHY interfaces with USB B connectors (FPGA controlled)