2
APPLICATION
The Night vision Biocular is a complex opticoel ectronic system for individual use. The device
consists of the objective lens, eyepiece and body. The body contains either a 1st + GN or a 2nd
+GN intensifier tube assembly with an integrated high voltage power source and two three-volt
battery housing. When installing the batter ies one should keep in mind that the polarity of the
batteries must coincide with the diagram on the body next to the battery housing cap.
The objective l ens protective c over is designed to protect the objective lens from dust and
scratches. It also acts as a daylight filter allowing you to test the Biocular in the daylight or other
bright light situations. The pinhole in the center of the protective cover allows the user to check
the operation ability of the device under the daylight conditions.
NOTE: Do not t est the sco pe under th e daylight c onditions even with the d aylight filter/l ens
capon for more than ten (10) minutes.
SMART DIGITAL TECHNOLOGY
Smart Total darkness Technology finally provides the user
total control in the hi -tech indu stry of night vision. The
Smart Series night vision monoculars have been designed
with the latest comp uter technolog y. On board computer
systems identify the users intention of looking through the
oculars. When the ocular is brought to the users eyes, the
monocular will automatically turn on. When removed from
the eyes the monocular will turn off ( you must engage the
proximity sensor for this feature to work) . The user wi ll
never have to worry about turning his or her monocular on
or off. Smart series monocular aut omatically sense when
it is no longer being used, and will shut off and enter their
sleep mode. All the controls and butt ons are digital. Even
if your batteries are l ow, don’t worry the s mart series will
let you know.
To use the smart sensor of the Night Shadow and save the life of the s cope as well as your
batteries, press both the “SL” key and the “+” key. The Voyager will now turn off when you move
away from the scope. It will turn back on when you move back to the scope.
1. ON/OFF indicator light - when power is ON, the LED will be green.
2. When the proximity sensor is activated the LED changes to red.
3. When IR is ON the LED is orange.
NOTE: You may notice the persistent green glow for up to five (5) minutes after you have turned
the unit off. This is normal for the 1st Gen. light intensifier tube.