ATON DH46X manual 4 ZONE OUT Connections, DHTP1 Speaker Connections, All rights reserved

Models: DH46X

1 23
Download 23 pages 34.97 Kb
Page 17
Image 17
Figure 3-4: ZONE OUT Connections

DH46X 4 Source, 6 Zone Digital Audio Expansion Router

DHTP1 Rear

DHTP1 Rear

DHTP1 Rear

Cat-5

Cat-5

DHTP1 Rear

DH46X

Cat-5

Cat-5

Cat-5

DHTP1 Rear

DHTP1 Rear

Figure 3-4: ZONE OUT Connections

DHTP1 Speaker Connections

The DH46X sends a digital audio signal to connected DHTP1 Touch Pads where it is amplifi ed and sent to speakers.

WARNING!: The DHTP1’s amplifier is capable of powering a single pair of 8-6 Ohm speak- ers. DO NOT connect speakers with a rating of less than 6 Ohms! DO NOT connect more than one speaker to either speaker connector of the DHTP1. In doing this, damage to the DHTP1 may occur and will void the products warranty.

To connect speakers to DHTP1 Touch Pads:

1.Ensure that system power is OFF!

2.Remove the SPEAKER CONNECTOR from the DHTP1

3.Strip speaker wire back 1/4"

4.Loosen speaker terminal screws on the speaker connectors

5.Insert speaker wires into terminals making sure to maintain +/- polarity

6.Tighten screws on speaker terminals

7.Re-connect the terminal strip to the SPEAKER CONNECTOR on the DHTP1

8.Connect speaker wires to the room speakers maintaining correct polarity

© 2008 • All rights reserved.

15

Page 17
Image 17
ATON manual 4 ZONE OUT Connections, DHTP1 Speaker Connections, DH46X 4 Source, 6 Zone Digital Audio Expansion Router