|
|
|
| TH1 04 |
|
| Installation Instructions and Owner s Guide | ||
| To set the day | FAN: displayed when | Current time | SETPOINT: |
| To set the | |||
| time | conventional temperature | and day | displayed when |
| To set the | control is selected |
| viewing or |
|
|
| setting the | |
| minutes |
|
| temperature |
|
| Heating |
| TIME: displayed |
| To access | indicators |
| |
| programming mode |
|
| when time needs |
|
|
| to be adjusted | |
| and view programs |
|
| |
|
|
|
| |
|
| Room |
| LP: displayed |
|
| temperature |
| |
| To exit a function |
| during a power | |
|
|
| ||
|
|
|
| failure |
|
| Current program |
|
|
| MODE: to select the | number when the |
|
|
| desired operating mode | Automatic mode |
| Current program |
|
| is active |
| number when |
| Temperature |
|
| Econo schedule |
|
|
| is active | |
| adjustment |
|
| |
|
|
|
| |
RESET: | buttons | Automatic |
| Econo |
| Manual | |||
To reset the |
| mode | mode | |
| mode | |||
thermostat |
|
|
| |
|
|
|
|
I NSTALLATI ON
This thermostat has been designed to control a RESISTIVE load not exceeding 3500 W @ 240 VAC or 1750 W @ 120 VAC, such as electric baseboards, convectors, radiant ceilings, floor heating sys- tems, etc.
It is not compatible with a low voltage controller used by a cen- tral heating system or systems using a contactor or a relay whose current is under 2 A.
TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN POWER PANEL TO AVOID ELECTRICAL SHOCK. Installation should be carried out by an electrician.
This thermostat is designed to be used with a
For a new installation, choose a location about 5 ft. (1.5 m) above the floor, facing the heating system and on an inside wall.
Avoid locations where there are air drafts (top of staircase, air outlet), dead air spots (behind a door), direct sunlight or con- cealed chimneys or stove pipes.
All cables and connections must conform to the local electrical code.
Special CO/ALR solderless connectors must be used when
connecting with aluminum conductors.
The wires are not polarized, therefore the connections can be made on either terminal.
PROVIDED PARTS
!One (1) TH104 thermostat
"Two (2)
#Two (2) solderless connectors
1 ) Connect the thermostat
Connect the rear wires to the power and load using solderless con- nectors for copper wires.
2 WIRES |
|
4 WIRES |
|
1/4 |