Aube Technologies TH104 Fi Rst Power On, Adj Ust The Ti Me And Day, Opti On S Selection, MANual

2) Secure the thermostat	Time display
Push the excess wire into	To change the time display format from 12 to
the electrical box to prevent	24 hours and vice-versa:
interference with the thermostat.		Press and hold	; do not release.
Secure the base to the electrical
		Reset the thermostat using a pointed object
box using the provided screws.				TO RESET
		(e.g. paperclip).
	￿			THE
The base can be secured on the		Release the	button.
				THERMOSTAT
left or right hand side of the electri-
cal box.	Temperature control type

3) Complete the installation					The TH104 is factory-set to use the proportional temperature con-
Once the thermostat is configured and installed, return power to					trol type (15-second cycles).
heating system.					Since this temperature control type uses a fast commutation rate, it
Keep the thermostat's air vents clean and free from obstructions.					is not compatible with fan-equipped systems. Also, it can also cause
					light flickering, especially in rural regions.
FI RST POWER ON					If you have a fan-equipped system, use the conventional tempera-
					ture control type (15-minute cycles). To change the type:
To	view the ambient	temperature,				Press and maintain		, do not release.
						Reset the thermostat using a pointed object (e.g. paperclip).
peel the lower-right section of the
sticker and remove it from the display.					￿	Release the	button.
When you first power on the					Following the change, the FAN indicator is displayed on the screen.
thermostat, the display					To revert to proportional control, repeat above steps.
indicates: 0:00, MO (Monday),			the
ambient temperature and the MANual						ADJ UST THE TI ME AND DAY
mode is selected (framed). The
default setpoint is preset to 20°C.
Protected memory					NOTE: You should select the options before you adjust the clock
During a power failure, all programs are protected. The thermostat					and day settings because using the reset button when selecting
					options will reset the clock.
display remains on for approximately 15 minutes after which the LP
indicator is displayed (low power). Only the time must be reset if the					The TIME icon flashes to indicate that the
power failure exceeds 6 hours. The thermostat will automatically					clock needs to be adjusted.
return to the previous mode when power returns.					! Press		to set the day.
OPTI ON S SELECTION					" Use the		and	buttons to
						set the clock.
The TH104 offers the following options:					# Press		to exit.
Temperature display			°C	°F		OPERATI N G MODES
Time display			24 h	12 h
Temperature control		Proportional		Conventional	The TH104 has three operating modes:
Highlighted options are factory pre-set. If these options fit your					AUTOmatic
requirements, go to the next menu.					This mode automatically runs your programs.
Temperature display					Press MODE until AUTO is outlined. The current
To change the temperature display from °C to °F and vice-versa:					program number is displayed above the AUTO icon.
	Press and hold	, do not release.			To temporarily bypass the current program, simply
					select the desired temperature using the tempera-
	Reset the thermostat using a pointed object (e.g. paperclip).				ture adjustment buttons. The new setpoint will be
					maintained until the beginning of the next program.
	Release the	button.
￿					MANual
					Maintains a constant temperature setpoint.
					Press MODE until MAN is outlined and select the
					desired temperature using the temperature adjust-
					ment buttons.

2/4400-104-000-A