Audio-Technica ATW-1811 manual Transmitter Batteries, Operating theTransmitter

11

Transmitter Batteries

ATW-T1801

ATW-T1802

Each transmitter uses two 1.5V AA batteries, not included. Alkaline type is recommended.	Battery Selection
Alwaysreplaceboth batteries.Make certain the transmitterpoweris Off beforereplacingbatteries.
1. Open the battery compartment door by sliding the catch down (on body-pack) or pushing in	TransmitterBattery
direction of arrow (on plug-on transmitter).	Installation

2.Observe correct polarity as marked on the metal contacts on the door and carefully insert two fresh 1.5V AA alkaline batteries.

3.Close the door, making certain the latch clicks securely in place.

After the batteries are installed, turn the power on by pressing and holding the Power/Mute button. The small power-on LED ( see a at left ) should light green and the LCD window should come on. If this does not happen, the batteries are installed incorrectly or they are depleted. The transmitter’s“fuel gauge” battery indicator in the LCD displays a maximum of four bar seg- ments. When it flashes “LOW.BAT”, the batteries should be replaced immediately to ensure con- tinued operation. (Additionally, the power-on LED will flash when the batteries are low.)

Battery Condition

a

POWER	SET	POWER/MUTE
UHFT1801-ATWTRANSMITTER
MUTE
SET

Operating theTransmitter

Toturn the transmitter on, press and hold the Power/Mute button until the power indicator lights TurningyourTransmitterOn & Off green, and the LCD window comes on (about 1-2 seconds). The operating frequency will show

in the window after the power-up sequence.

To turn the transmitteroff, press and hold the Power/Mutebutton again, until the power indicator and the LCD window are extinguished (about 1-2 seconds). The LCD window will show

“PWR.OFF” before shutdown.

NOTE: Set your transmitter and receiver to identical frequencies.	How to Set Frequencies
	on yourTransmitter

1.Turn transmitter on.

2.Press the Set button once and the small word “MENU” will appear above the frequency.

3.Press the Set button again and the small flashing word “EDIT” will appear to the right of “MENU”.

4.Use the Up/Down arrows to change the transmitter frequency. Press either arrow for 25 kHz steps, or hold down either arrow for rapid cycling through the range. Frequencies “wrap around” when the top or bottom of the band is reached. Select the exact frequency displayed on the receiver.

5.To activate this frequency selection, press and hold the Set button until the word “STORED” appears in the transmitter’s window. (If you do not wish to complete this selection, just press the Set button once: the word “ESCAPE” will appear briefly in the window and the transmitter will return to the Menu mode.)

6.When finished entering a frequency,press the Up arrow once to move to “QUIT”.Then press the Set button once to exit the menu. The word “MENU” in the transmitter window will go off, indicating the return to normal operation.

1.	Turn transmitter on.		How to Access & Use the Function Menu
2.	Press the Set button once; the small word “MENU” will appear above the frequency.		on yourTransmitter
3.	When in the Menu mode, use the Up and Down arrowsto cyclethroughthe followingfunctions:
	• Frequency	• Input Select (body-pack only)
	• RF Power	• Reset to Defaults
	• Audio Input Level	• Quit (exit menu)

•Power/Mute Locks

4.To make a change in the default setting:

•Press Set button once;

•Press Up or Down arrow until you reach desired setting;

•Press and hold Set button until the word “STORED” appears in the LCD window.

•(If you do not wish to complete this selection, just press the Set button once: the word “ESCAPE”will appear brieflyin the windowand the transmitterwill returnto the Menu mode.)