Audio-Technica p51857_1800 Tips for Best Results, Available Accessories, Receiver Accessories

14

Operating the Transmitter (continued)

Restore Default Settings 1. A “PRESET” selection in the menu allows you to reset all transmitter functions to their factory-default values.

2.Press the Set button once to move to Menu mode.

3.Press the Up arrow twice to move to “PRESET” in the LCD window.

4.Press the Set button once and “LOAD” will appear in the LCD.

5.Press and hold the Set button until “DEF” appears in the LCD.

6.Press and hold the Set button until “LOADED” appears briefly in the LCD. The window will then revert to “PRESET”.

7.Press the Down arrow once to move to “QUIT”.

8.Press the Set button once to exit the Menu mode and return to normal operation, with all factory-default settings restored.

Tips for Best Results

1.Use only fresh alkaline batteries. Always replace all batteries. Do not use “general purpose” (carbon-zinc) batteries.

2.Position the dual-channel receiver so that it has the fewest possible obstructions between it and the normal location of the transmitters. Line-of-sight is best.

3.The transmitters and the dual-channel receiver should be as close together as conveniently possible, but no closer together than three feet.

4.The receiver antennas should be in the open and away from any metal.

5.Each transmitter-receiver pair must be set to the same frequency.

6.Only one transmitter on a given frequency should be “on” at a time.

7.The power switch on the transmitter has four positions: “Ext.,” “Off”, “1” and “Both”.

8.If the “Out Level” of either receiver channel is set too high, it may over-drive the input of the camera/mixer or clip the output of the receiver, causing distortion. Conversely, if the receiver output is set too low, the overall signal-to-noise ratio of the system may be reduced.

9.You need to change channels 1) when a strong interference signal is received, 2) when the channel breaks down, or 3) during multiple-system operation in order to select an interference- free channel. Always turn the units off before changing frequencies.

10. Turn the receiver and transmitter off when not in use. Remove the batteries during long-term storage.

Available Accessories

Wireless Essentials® Microphones and Cables (all Wireless Essentials accessories are terminated for use with UniPak™ transmitters)

AT829cW	Cardioid condenser lavalier microphone
MT830cW	Omnidirectional condenser lavalier microphone

MT830cW-TH “Theater” model, same as MT830cW except beige-color mic and cable

AT831cW	Cardioid condenser lavalier microphone
AT889cW	Headworn noise-cancelling condenser microphone
AT892cW	MicroSet® headworn omnidirectional condenser microphone
AT892cW-CO	Same as AT892cW except cocoa-color mic, earset and cable

AT892cW-TH “Theater” model, same as AT892cW except beige-color mic, earset and cable

AT898cW	Subminiature cardioid condenser lavalier microphone
AT899cW	Subminiature omnidirectional condenser lavalier microphone
AT899cW-TH “Theater” model, same as AT899cW except beige-color mic and cable
ATM350cW	Cardioid condenser instrument microphone
ATM73cW	Headworn cardioid condenser microphone
ATM75cW	Headworn cardioid condenser microphone
PRO 8HEcW	Headworn hypercardioid dynamic microphone
PRO 35cW	Cardioid condenser instrument microphone
U851cW	Cardioid condenser boundary microphone
U857ALcW	Cardioid condenser gooseneck microphone
AT-GCW	Hi-Z instrument/guitar cable with 1/4" phone plug
XLRW	Connecting cable for UniPak transmitter with an XLRF-type input connector,
	for Lo-Z microphones with XLRM-type output terminations

Receiver Accessories	RF Cables	Low-loss design, 50 ohm impedance, with BNC-to-BNC connectors:
	AC12	RG58-type cable (12')
	AC25	RG8-type cable (25')
	AC50	RG8-type cable (50')
	AC100	RG8-type cable (100')
Transmitter Accessories	ATW-RMS1	Remote mute switch designed to be installed between a wireless microphone
		using an HRS-type connector and its associated body-pack wireless transmitter
	ATW-RCS1	Remote momentary-mute/cough switch designed to be installed between a
		wireless microphone using an HRS-type connector and its associated body-pack
		wireless transmitter

Visit www.audio-technica.com for detailed information on all of our wireless accessories.