Vanguard Managed Solutions 7300 Series installation manual Accessing the Control Terminal Port

			Accessing the Control Terminal Port
Accessing the Control Terminal Port
Introduction
	Once you power up a Vanguard 7300, you can access the Control Terminal Port
	(CTP) from the PC or terminal attached to the CTP port. To view the power-up
	diagnostics, connect to the CTP port before you power up the Vanguard 7300.
		Note
		For detailed information on accessing and using the CTP, refer to the Vanguard
		Basic Configuration Manual (Part Number T0113) on the Vanguide CD-ROM.
Procedure
	Use the procedure in this table to access the Vanguard 7300 CTP main menu:
		Note
		This procedure assumes you have a PC or terminal connected to your Vanguard
		7300 using the CTP-access cable.
		Step	Action

1Set your terminal, or terminal emulation software, to VT100, 9600 bps, 8 bit, no parity, 1 stop bit.

2Type <CR> until the OK prompt appears.

3At the OK, type atds0 <CR>. The CTP banner appears. If the banner does not appear, repeat the steps to verify the correct procedure.

4If no password is set, type <CR> at the password prompt.

CTP Access Via	After the node is configured and operational, there is another way to connect to the
Remote Telnet	CTP. That is by remote access over your established IP network.
	You can telnet into the node from an IP network-based PC or workstation. Connect
	to the CTP by entering atds0 <CR> after the Vanguard 7300’s OK prompt.
Vanguard
	The Vanguard Embedded Web Navigator allows web management through a
Embedded Web	browser. Using any web browser, you can access the web navigator through a TCP/
	IP network. For more information on the Embedded Web reference the Software
	Release Notice (Part Number T0001-41)
CTP Access Via
	If the Vanguard 7300 is operating in an X.25 network, or if Frame Relay Annex-G is
Remote X.25 or	used to connect with other Vanguard Managed Solutions Network Access Product
Frame Relay	nodes, access the Vanguard 7300 CTP remotely by making a Switched Virtual
Network	Circuit (SVC) call to the node and specifying sub address 98.

Operating Your Vanguard 7300 4-3