Vanguard Managed Solutions 7300 Series Installing the Vanguard 7300 in a Rack, Grounding

			Installing the Vanguard 7300 in a Rack
Installing the Vanguard 7300 in a Rack
Introduction
	This section explains how to install a Vanguard 7300 router chassis in an industry-
	standard 19-inch EIA equipment rack.
			Note
			Vanguard 7300 Series routers are not to be used standalone on a tabletop or
			stacked on top of one another.
		Warning
	Two people are required to install a Vanguard 7300 Series router in an equipment
	rack. To prevent personal injury or damage to equipment, mount the router no higher
	than the mid-point of the rack.
	Avertissement
	Deux personnes sont nécessaires pour le montage d’un routeur Vanguard série 7300
	dans un cadre d’équipement.
	Ne montez pas le routeur plus haut que le centre du cadre pour empêcher des
	blessures ou des dommages à l’équipement.
	Achtung
	Es werden zwei Personen benötigt, um einen Vanguard 7300 Series Router in
	einen Einschubschrank einzubauen.
	Um Verletzungen des Personals oder Beschädigungen des Geräts vorzubeugen, darf
	der Router höchstens in mittlerer Höhe des Einschubschrankes montiert werden.
Grounding the
	Be sure to mount the chassis with mounting hardware that give a good electrical
Vanguard 7300	connection between the screws or bolts and the mounting surface.

Caution

Failure to observe proper grounding practices may cause a variety of noise, electrostatic discharge and RFI (Radio Frequency Interference) problems.

Caution

Avoid touching areas of integrated circuitry. Static discharge can damage circuits.

Caution

Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the “ESD Bond Point” on the front or rear of the chassis as a ground. Secure the ESD strap to your wrist and to ground throughout any installation procedures.

Vanguard 7300 Installation 3-15