Vanguard Managed Solutions 7300 Series Installing the Ethernet PMC on the MPC750 CPU Card

Removing and Replacing the CPU Card and CPU Mezzanine Card (PMC)

Installing an To add a 10/100BaseT Ethernet PMC, install the first PMC in the MPC750 CPU Ethernet PMC on Card PCI PMC location beside the Memory PMC. Use the steps in this table to the MPC750 CPU install the Ethernet PMC on the CPU Card:

Card

Note

To remove a 10/100BaseT Ethernet PMC, reverse steps 4-6 in this table:

Step Action

1Turn off power to the Vanguard 7300.

2Disconnect any cables attached to the front of the MPC750 CPU card.

3Remove the CPU card from the enclosure according to the instructions in the “Removing and Replacing the MPC750 CPU Card” section on page 5-12.Be sure to place the CPU card on a clean, grounded, and static-free surface.

Caution

Avoid touching areas of integrated circuitry; static discharge can damage these circuits.

4Remove the filler panel from the PCI PMC location on the front of the CPU card by gently pushing it out from the back of the rail.

5Position the PMC on top of the card as shown in Figure 5-9. Slide the front edge connectors into the opening labelled “PCI Mezzanine Card”.

6Press the PMC down onto the top of the CPU card. The connectors on the underside should connect smoothly with the J11/12/13/14 connectors.

7Insert the short screws at the corners of the PMC and into the standoffs on the CPU Card. Tighten the screws.

8Re-install the CPU card into PMC slot 1 on the enclosure according to the instructions provided in “Removing and Replacing the MPC750 CPU Card” section on page 5-12.

Ethernet PMC Serial No.

Location

Figure 5-9. Installing the Ethernet PMC on the MPC750 CPU Card

5-14 Modifying Your Vanguard 7300