Vanguard Managed Solutions 7300 Series Removing and Installing the Exhaust Fan Module

		Replacing Power Supplies and Cooling Fans, 7310 Version 1
Removing and Installing the Exhaust Fan Module
Introduction
	The Vanguard 7310 Version 1 Exhaust Fan Module contains the rear exhaust fans.
	The module is hot-swappable; it can be removed without turning off the system
	power and without disrupting system service.
	This section describes how to remove or install the Exhaust Fan Module.
Procedure
	Refer to Figure 6-4and these steps to remove the Exhaust Fan Module:
		Note

The Exhaust Fan Module is hot-swappable and can be removed without disconnecting the power source and without disrupting system service.

1) Loosen the single captive screw above the front ESD bonding point.

2) Carefully pull on the module handle to withdraw the module out the front of the chassis and away from the midplane.

Front of Chassis

Captive Screw

Exhaust Fan

Module

Figure 6-4. Removing the Vanguard 7310 Version 1 Exhaust Fan Module

Replacing Power Supplies and Cooling Fans 6-5