Vanguard Managed Solutions 7300 Series Configuring Local Subscriber Address, Addresses

Vanguard 7300 Port Configuration

Configuring the

Local Subscriber

Address

The Local Subscriber Address parameter is accessed using the Voice Port Record Options. To configure your Local Subscriber Address, select the Local Subscriber Address parameter, and then enter the phone number you wish to register. That value is registered with the gatekeeper as an E.164 address.

This table shows the range, default, and description of the Local Subscriber Address parameter:

Range:	0 to 21 alphanumeric characters <space> blanks the field
Default:	(blank)
Description:	Specifies the Local Subscriber Address when the remote port is an
	ISDN or Q.SIG port.
	The Local Subscriber Address must be specified when Call
	Control parameter is set to Switched and the Use Local Subscriber
	Address parameter is Enabled. Under this configuration, this Local
	Subscriber Address is used to search the Voice Switch Table.

Changing the E.164 If you change an E.164 address, you must force the registration with the gatekeeper.

addresses	Use the steps in this table to re-register a new E.164 address:
	Step		Action
	1	Reconfigure the IP address of the gatekeeper in the Vanguard gateway
		using the H.323 Node Parameters. Figure 4-12illustrates the H.323 Node
		Parameter record.
	2	Boot the H.323 Node Parameters to unregister the gateway.
	3	Configure the gatekeeper’s IP address back to the original address.
	4	Boot the H.323 Node Parameters to reregister with the gatekeeper.
	Node:	Address:	Date:Time:
	Menu: Configure		Path:

H.323 Node Parameters

--Gatekeeper IP Address --Gatekeeper Port Number --Gateway Time to Live Timer --Prefix

Figure 4-12. H.323 Node Parameter Menu

Operating Your Vanguard 7300 4-21