Vanguard Managed Solutions 7300 Series Removing and Replacing the Token Ring Card, Slot

Removing and Replacing the Token Ring Card

Removing and Replacing the Token Ring Card

Installing the Token When installing a Token Ring card, the first Token Ring card should be placed in

Ring Card card slot 2, the first slot beside the CPU Card. Install subsequent Token Ring cards in subsequent slots.

Use the steps in this table to install a Token Ring Card in a Vanguard 7300 enclosure:
Step	Action
1	Open the ejector levers.
2	Align the Token Ring Card with the card rails in the Vanguard 7300 chassis
	slot.
3	Carefully insert the Token Ring Card in the card rails and slide the card
	until you feel resistance.
4	Simultaneously press the ejector levers inward until they lock.
5	Tighten the captive screws.
6	Reconnect any connector cables.

Removing the	Use the steps in this table to remove the Token Ring Card from the Vanguard 7300
Token Ring Card	enclosure:
	Step		Action
	1	Disconnect any cables attached to the cards connectors.
	2	Loosen the screws.
	3	Open the ejector levers on the Token Ring card.
	4	Pull the Token Ring card from the enclosure.
	5	Place the Token Ring card on a clean, grounded, and static-free surface.
			Caution
		Avoid touching areas of integrated circuitry; static discharge can
		damage these circuits.

5-34 Modifying Your Vanguard 7300