Vanguard Managed Solutions 7300 Series How to Order, Connections, Interface Type, Code

FCC Part 68 and Telephone Company Procedures and Requirements

FCC Part 68 and Telephone Company Procedures and Requirements

Introduction	This section describes the FCC Part 68 Telephone Company Procedures and
	Requirements for DSU, T1, T3, and ISDN Interfaces.

Before You Begin Before a Vanguard 7300 Series router can be connected to the network, you must do the following:

•Provide the local telephone company with the equipment’s registration number.

•Order the proper connections.

How to Order	To order the proper connections, provide the telephone company with the following
Connections	information:
	•	Interface type.
	• Required USOC jack connector number.
	•	Service code.
	•	Facility interface codes.
	Interface Type		USOC Jack	Service Code	Facility Interface
			Connector		Code
	ATM and Voice Server		RJ48C	6.0N	04DU9-BN
	PMC versions of the T1/				04DU9-DN
	PRI Digital Interface				04DU9-1KN
					04DU9-1SN

Troubleshooting If any of your equipment is not operating correctly, immediately remove it from the Your Connection telephone line before damaging the network. If the telephone company is aware of the problem, they might temporarily disconnect your service. Whenever possible, the

telephone company notifies you in advance of the disconnection.

If advance notice is not feasible, you are notified as soon as possible. Once you are notified, you can correct the problem. If necessary, it is your right to file a complaint with the FCC.

C-2