Vanguard Managed Solutions 7300 Series installation manual Removing and Replacing the Serial Card

Removing and Replacing the Serial Card and Serial Rear Transition Module

Removing and Replacing the Serial Card and Serial Rear Transition Module

Introduction This section provides procedures that explain:

•Removing and Replacing the Serial Card

•Removing and Replacing the Serial Rear Transition Module

Card Orientation Figure 5-16illustrates the card orientation for the Serial Card and Rear Transition Module pair. The Serial Card must be installed from the front and the Serial Rear Transition Module must be installed from the rear of the Vanguard 7300 chassis.

Serial Card Serial Rear Transition Module

Serial No.

Location

Front Panel

Rear Panel

Serial No.

Location

			Midplane
		Figure 5-16. Serial Card and Rear Transition Module Orientation
	Removing and Replacing the Serial Card
Description
		This section explains how to remove and install the Serial Card.
			Note
			Be sure to review all applicable warnings and cautions in the “Hot-Swapping
			Cards and Modules” section on page 5-2before you begin.

Modifying Your Vanguard 7300 5-31