Vanguard Managed Solutions 7300 Series installation manual Procedures, Removing, Replacing

Removing And Replacing Vanguard 7300 Front Covers

Procedures

Introduction	This section provides instructions for removing and replacing the Vanguard 7310
	Version 1 front covers.
	These are the procedures provided:
	For the Vanguard Version 1 7310:
	• Removing and replacing the hinged panel on the right
	• Removing and replacing the fixed panel on the left
	• Running front cables in the cable channel behind the 7310 fixed panel
	For the Vanguard Version 1 7330:
	• Removing and replacing the hinged 7330 front cover panel on the left
	• Removing and replacing the fixed 7330 panel on the right
	• Running front cables in the cable channel behind the 7330 fixed panel
Removing and
	Use the procedure in this table to remove and replace the 7310 Version 1 hinged
Replacing	front cover:
Vanguard 7310
Version 1 Front
Covers
	Step	Action
	1	Open the 7310 hinged front cover (right side) and locate the two self-
		contained hinge assemblies on the right side of the chassis.
	2	Support the front cover while pushing down on the top spring-loaded hinge
		pin. Rotate the pin into its lock position.
	3	Pull up on the bottom spring-loaded hinge pin, and rotate it to its lock
		position.
	4	With the spring-loaded hinge pins clear, pull the cover forward until it is
		free.
	5	Place the cover on a flat level surface, painted side up.
	6	To replace the cover, line up the hinge assemblies and rotate the pins until
		they lock in place.
	7	Close the hinged cover and keep it closed except for maintenance or
		re-cabling.

3-10 Vanguard 7300 Installation