Vanguard Managed Solutions 7300 Series Power-Up Procedure, Meaning Color Indication

Power-Up Procedure

Power-Up Procedure

Introduction		This section explains how to power-up a Vanguard 7300 Series router. To power
		down your Vanguard 7300, set the power switch to the off position.
			Note
			Before you begin, be sure to review all applicable warnings and cautions in the
			“Electrostatic Discharge Precautions” section on page 3-7.
Power-Up
		Use the procedure in this table to power-up your Vanguard 7300:
Instructions
			Step					Action
		1			Check that all the cards are fully inserted and secured.
		2			Check that all empty or open slots are covered with slot panels.
		3			Make sure the AC power cord(s) are plugged in. For all Vanguard 7300
					DC powered units, be sure that they are wired properly.
		4			Flip the Vanguard 7300 AC or DC power switches to the on position. For
					DC powered units (Version 1) depress the circuit breaker switch.
						Note
					If you have two power modules, set the power switches to the on position.
		5			Check that the fan(s) operate correctly.
		6			Check the front panel displays for the proper LED sequences.
Power-Up LED
		When you apply power, the fan starts and the four LEDs on the front of the CPU
Values		activate. This table lists the LED values:
	LED			Meaning			Color	Indication
	BFL			Board Failure			Yellow	• OFF - Normal CPU card operation
								• ON - Hardware failure
								• Blinks once/sec. - Waiting for cold loader
								• Blinks twice/sec. - Coldloading done, waiting
								for or downloading system software
	CPU			CPU Activity			Green	• OFF - Indicates no CPU activity
								• ON - Indicates CPU activity
	PCI			PCI Activity			Green	• OFF - Indicates no PCI bus activity
								• ON - Indicates PCI bus activity
	CPCI			CPCI Activity			Green	• OFF - Indicates no Compact PCI bus activity
								• ON - Indicates Compact PCI bus activity
		Next, each pre-installed card displays power-up status on its own LEDs. During the
		power-up process, a series of messages appears on the operator console terminal.

4-2 Operating Your Vanguard 7300