Vanguard Managed Solutions 7300 Series installation manual FXS Port and FXS Virtual Port Menu

Vanguard 7300 Port Configuration

Registering E.164 The phone number used in the Local Subscriber Address parameter is registered as

Numbers E.164 numbers. The Local Subscriber Address parameter is accessed from the Voice Port Record of the FXS/FXO interface types. Figure 4-11shows the FXS Virtual Port Menu.

Node:	Address:	Date:Time:
Menu: Configure		Path:

Node

Port

Port Number: 2000 to 3000 (Enter a virtual port number.)

Port Type: Voice

Access Type: Digital

Interface Type: FXS

--Signalling Mode --PCM Mode --Compression Rate --VAD Control --Smoothing Delay --Echo Canceller --Echo Return Loss --Input Signal Level --Output Signal Level --FAX Support --FAX Rate

--Call Control

--Call Mnemonic

--Autocall Timeout

--Autocall Retries

--Use Local Subscriber Address --Group Subaddress (Hunt Group) --No Answer Timeout --Variable Digits Timeout --Billing

--Local Subscriber Address

--Enhanced Debugging

--Rx Signalling State Change Filter --T1/E1 Rx Idle (on-hook) State --T1/E1 Tx Idle (on-hook) State --T1/E1 Rx Active (off-hook) State --T1/E1 Tx Active (off-hook) State --T1/E1 Ringing State

--T1/E1 No Ringing State --T1/E1 Busyout State --Rx Disconnect Timer --Line Error Recovery Time

--Rx Minimum Flash Hook Time

--Rx Maximum Flash Hook Time

--Re-configure DTMF/Pulse digits and Wink/Delay Timer Parameters?

--Re-configure Call Progress Tone Parameters? --Packet Delay Measurement Period

Figure 4-11. FXS Port and FXS Virtual Port Menu

4-20 Operating Your Vanguard 7300