Cabling Procedures

Cabling the

There is a DB9 connector on the front of the MPC750 CPU card for connecting an

Operator Console

operator console to the Vanguard 7300. An operator console can be an asynchronous

 

VT100 terminal (or a PC with asynchronous VT100 terminal emulation capability.)

 

The operator console is needed initially for configuring software and running

 

diagnostic programs. See Figure 3-22for the location of the DB9 CTP port.

Use these steps to cable the operator console:

1)Attach an EIA232 crossover cable with a DB9 plug connector to the DB9 CTP port, COM 1, on the CPU card.

2)Connect the other end to the operator console VT100 terminal or PC.

Note

The DB9 CTP port appears as a DTE device and has the same pinout as the standard PC COMM port. For cable and port pinouts, refer to Appendix B, Vanguard 7300 Cable Connectors and Pinouts.

 

IBM750FX CPU Card

Introduction

 

 

 

The connectors on the front of the CPU card are show in Figure 3-23.The

 

 

IBM750FX CPU always resides in chassis slot 1 of your Vanguard 7300.

These cable connections can be made to the IBM750FX CPU card front panel:

Operator Console to the RJ45 CTP port

Two RJ45 Ethernet Connections to the 10/100/1000 BaseT port

Two PCI PMCs

Abort/Reset

Push Button Switch

Power,

Diagnostic, Hot Swap

System LEDs

PMC 2

PMC 1

 

 

P

A/R

 

 

D

 

 

 

 

 

S

HS

COM

ETH 1

ETH 2

 

PCI PMCs

RJ45 CTP Port

10/100/1000

 

10/100/1000

BaseT Ethernet

 

Port

 

BaseT Ethernet

 

 

 

Port

 

Figure 3-23. IBM750FX CPU Card Connectors

The Ethernet address of the CPU card’s on-board Ethernet port appears on a bar-code label just behind the Ethernet PMC slot on the CPU card front panel.

Pinouts for the IBM750FX CPU card are provided in Appendix B, Vanguard 7300 Cable Connectors and Pinouts.

3-30

Vanguard 7300 Installation

Page 104
Image 104
Vanguard Managed Solutions 7300 Series installation manual IBM750FX CPU Card, Operator Console