Vanguard Managed Solutions 7300 Series Installing Ethernet PMCs on the Carrier Expansion Card

Removing and Replacing Carrier Expansion Cards and Mezzanine Cards (PMCs)

Installing Ethernet PMCs on the Carrier Expansion Card

Introduction	This section describes how to install PMCs on the Carrier Expansion Card. The
	Carrier Expansion Card provides two slots for Ethernet PMCs. The PMCs that can
	be installed on the Carrier Expansion Card are 10/100 BaseT Ethernet PMCs.
	Figure 5-12shows the Carrier Expansion Card PMC locations.

Ethernet

PMC

Serial No.

Locations

Serial No.	PMC Slot1	PMC Slot2
Location

Figure 5-12. PMC Slots on the Carrier Expansion Card

Populating the	When installing Carrier Expansion Card PMCs, install a PMC in the first slot, slot 1,
Carrier Expansion the lefthand slot, before you install a second PMC in the Slot 2 on the right.
Card
Installing a Carrier Use the steps in this table to install a Carrier Expansion Card PMC:
Expansion Card			Note
PMC
			To remove an Ethernet PMC from a Carrier Expansion Card, remove the four
			short screws at the corners of the PMC and remove the PMC from the card
			connectors.
		Step		Action

1Remove the Carrier Expansion Card from the enclosure according to the instructions provided in “Removing the Carrier Expansion Card” section on page 5-19.

5-20 Modifying Your Vanguard 7300