Vanguard Managed Solutions 7300 Series Without disrupting system service, Exhaust Fan Module

		Replacing Power Supplies and Cooling Fans, 7310 and 7330 Version 2
Removing and Installing the Exhaust Fan Module
Introduction
	The Vanguard 7310 and 7330 Version 2 contains a rear exhaust module. The module
	is hot-swappable; it can be removed without turning off the system power and
	without disrupting system service.
	This section describes how to remove or install the Exhaust Fan Module.
Procedure
	Refer to Figure 6-8and these steps to remove the Exhaust Fan Module:
		Note

The Exhaust Fan Module is hot-swappable and can be removed without disconnecting the power source and without disrupting system service.

1) Loosen the four screws

2) Carefully withdraw the module from the rear of the chassis and away from the midplane.

Figure 6-8. Removing the Vanguard 7310 and 7330 Version 2

Exhaust Fan Module

Installing an	To install the Exhaust Fan Module:
Exhaust Fan
Module	Step	Action

1Insert the Exhaust Fan into the slot and insure that it is seated firmly.

2Tighten the (4) mounting screws.

Replacing Power Supplies and Cooling Fans 6-13