Replacing Power Supplies and Cooling Fans, 7310 and 7330 Version 2

Removing and Installing the Intake Fan Module

Introduction

The Vanguard 7310 and 7330 Version 2 Intake Fan Module contains a single fan.

 

The module is hot-swappable; it can be removed without turning off the system

 

power and without disrupting system service.

 

This section describes how to remove or install the Intake Fan Module.

Procedure

 

 

 

Refer to Figure 6-4and these steps to remove the Intake Fan Module:

 

 

 

Note

 

 

 

 

 

 

 

 

 

The Intake Fan Module is hot-swappable and can be removed without

 

 

 

disconnecting the power source and without disrupting system service.

 

1) Loosen the two screws

 

2) Carefully withdraw the module out the front of the chassis and away from the

 

 

 

midplane.

Figure 6-9. Removing the Vanguard 7310 and 7330 Version 2

Intake Fan Module

Installing an Intake To install the Intake Fan Module:

Fan Module

Step

Action

1Insert the Intake Fan into the slot and insure that it is seated firmly.

2Tighten the (2) mounting screws.

6-14

Replacing Power Supplies and Cooling Fans

Page 188
Image 188
Vanguard Managed Solutions 7300 Series installation manual Removing and Installing the Intake Fan Module