Vanguard Managed Solutions 7300 Series Procedure for Rack-mounting Version 1 Rack- mounting

Installing the Vanguard 7300 in a Rack

Procedure for Rack-mounting

Version 1 Rack- mounting

Figure 3-10shows the mounting hardware locations on the flanges of the Vanguard 7310 Version 1. For the locations on the Vanguard 7330 Version 1, refer to Figure 3-11,For the locations on the Vanguard 7310 and 7330 Version 1, refer to Figure 3-12.Use standard rack-mounting hardware (not supplied) to secure the chassis in the rack.

Use these steps for rack-mounting a 7310 and 7330 Version 1 Series router:

1)Remove the front covers. (See the “Removing And Replacing Vanguard 7300 Front Covers” section on page 3-8.)

2)Two people are required to position the chassis and slide it into the front of the rack.

3)Attach the front of the chassis to the rack:

•Secure the Vanguard 7310 Version 1 with mounting hardware at four locations, two on each side of the front panel (Figure 3-10)

•Secure the Vanguard 7330 Version 1 at eight locations, four on each side of the front panel (Figure 3-11)

PORT1

PORT2

RST

ABT

BFLCPU

CPCIPCI

ACT 100bT

LINK

PCI MEZZANINE CARD

10/100 BASE T

COM 1

PORT2

USB 1

USB 0

EXTPWR

PORT1

PORT2

PORT1

LINK

ACT 100bT

LINK

ACT 100bT

P M C

2

P M C

1

RESET

11

7

3

SWAP

8

W A N

0

D E B U G

HOT

4

Universal

Serial I/O

EXT PWR

Figure 3-10. Rack Mount Hardware Locations - Vanguard 7310

3-16 Vanguard 7300 Installation