Audio-Technica pro series 5 wireless systems manual Receiver Controls and Functions

3

Pro Series 5 Installation and Operation

Receiver Controls and Functions

1 2 3 4 5 6 1

Figure A — Front Panel Controls and Functions

1.ANTENNAS: Position the antennas as shown in Figure A Fully extend both antennas by pulling on the endcaps.

2.AF PEAK INDICATOR: Indicates when maximum transmitter modulation without distortion has been reached. Not affected by position of Volume control (Fig. B).

3.LED WINDOW: LED Display indicates channel setting and scanning operation.

4.DIVERSITY INDICATORS: Indicates which antenna (A or B) has better reception and is in operation.

5.SELECT BUTTON (for manual channel selection): Press the Select button repeatedly until desired channel is reached. Press and hold the Set/Scan button to manually set the receiver to indicated channel. Channel number will stop flashing. (A brief touch of the Set/Scan button will revert to previously set channel). If the Set button is not pressed within 10 seconds to confirm the selection, the system will revert to its original channel.

6.SET/SCAN BUTTON: The Set/Scan button can be used in two

ways: 1) in conjunction with the Select button to permit manual selection of an operating channel in Manual Set Mode (see

“Select button” description above); and 2) Automatic Scan/Set Mode, to initiate the automatic channel scan and selection, as follows: Automatic Scan/Set Mode: Press and hold the Set/Scan button for about two seconds. The current channel will flash three times quickly; then the system will begin to scan for the next open channel. When it finds an open channel, it will flash the open channel three times and then set the channel. (If an open channel is not found, the automatic scan will return to the original channel and flash 5 times.)

1 2 3 4 5

Figure B — Rear Panel Controls and Functions

1.UNBALANCED AUDIO OUTPUT JACK: 1/4" phone jack. Can be connected to an unbalanced aux-level input of a mixer, guitar amp or tape recorder.

2.AF LEVEL (VOLUME) CONTROL: Adjusts audio output level of both AF Output jacks; maximum output is fully clockwise.

3.BALANCED AUDIO OUTPUT JACK: XLRM-type connector. A standard 2-conductor shielded cable can be used to connect the receiver output to a balanced microphone-level input on a mixer or integrated amplifier.

4.CORD HOOK: Loop the cord around the cord hook to keep the DC plug from pulling out accidentally.

5.POWER INPUT JACK: Connect the DC plug from the included in-line AC adapter.