16
Troubleshooting
Symptom | Cause | Remedy |
Display is off | Power cord incorrectly plugged | Make sure the power cord is correctly |
No sound |
| plugged into the wall outlet |
| Check fuses in the fuse panel (after | |
|
| unplugging the power cord from the wall |
|
| outlet) above the IEC inlet and replace |
|
| them with new ones of the same type |
Display is on | Faulty or incorrectly plugged connectors | Check cords and their connection |
No sound | between Maestro CD 192/24 and the |
|
| amplifier |
|
| Incorrectly selected source on the amplifier | Check that Maestro CD 192/24 is correctly |
|
| selected through the amplifier ins |
CD player works but the display is off | Faulty front panel | Contact your Audio Analogue retailer for |
|
| connections check and front panel |
|
| substitution |
Remote controller doesn’t work | No battery/ | Place/replace battery (2 ‘AAA’ batteries) |
| You’re standing too far or on an exceeding | Get closer to the unit or reduce angle |
| angle from the front panel |
|
If the suggested remedies should not work or the problem is not shown in the list above, please contact your local Audio Analogue retailer.
RICERCA GUASTI
Sintomo | Causa | Rimedio |
Display spento | Cavo di alimentazione non inserito | Controllare che il cavo sia ben inserito |
Nessun suono | correttamente | nella presa di rete |
| Fusibili bruciati | Controllare i fusibili nel portafusibili (dopo |
|
| aver staccato il cavo di alimentazione dalla |
|
| presa di rete) sopra la presa IEC ed |
|
| eventualmente sostituire con altri dello |
|
| stesso tipo |
Display acceso | Cavi di segnale tra Maestro CD 192/24 e | Controllare lo stato dei cavi e/o la corretta |
Nessun suono | amplificatore non connessi correttamente | connessione |
| oppure difettosi |
|
| Sorgente non selezionata correttamente | Controllare che il Maestro CD 192/24 sia |
| sull’amplificatore | selezionato correttamente con il selettore |
|
| degli ingressi dell’amplificatore |
Il CD player funziona | Scheda frontale difettosa | Contattare il vostro rivenditore Audio |
ma il display è spento |
| Analogue per una verifica dei collegamenti |
|
| ed eventuale sostituzione della scheda |
Il telecomando non funziona | Batterie scariche o mancanti | Inserire o sostituire le batterie (2 ministilo |
|
| tipo ‘AAA’) |
| Eccessiva distanza dal pannello frontale | Avvicinarsi di più all’apparecchio o |
| dell’apparecchio o angolo non corretto | cambiare angolo |
Se i rimedi suggeriti non dovessero funzionare oppure il problema non è riportato nella lista, contattate il vostro rivenditore Audio Analogue