10.Remove and retain the handle which mounts to top of the “B” pillar.
11.Unsnap the cover from upper and lower mounting bracket for seat belt. Remove and retain TORX head bolt and bracket. Carefully pull panel away from side of vehicle. Unsnap upper door trim from headliner and lay aside. See Figure 11.
FIGURE 11
12. Measure 7” from rear A/C control opening toward rear of vehicle. Using a razor knife, carefully cut an opening that is 4” wide x 8” long. Make sure that the 4” width is centered in the vehicle. See Figure 12.
13. Insert the 6” x 14” piece of plywood (item 8 pg 2 ) through opening and rotate 90°.
FIGURE 12
8
