Audiovox 1187025, 27PL installation instructions Installation of Console

6.Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to the B-pillar. Down the B-pillar to the floor. Route the power lead to a fused accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See Figure 4. Connect per instructions included with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna.

INSTALLATION OF CONSOLE

7.Raise console (item 6 pg 2) into position against the headliner. Install 4 screws (item 1 pg 2) and 4 washers (item 3 pg 2) to secure console into place.

8.Install appropriate plastic insert into recess in the main console. Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video

system housing.

9. Raise video system into approximate position and connect all wiring to components. Connect wiring and cabling to video system per instructions included with video system.

10.Check function of all components and lights. See operating instructions for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area.

11.Insert video system into opening in console. Note: Make sure wires

do not get pinched between video system and console. Align

holes in housing with holes in mounting bracket. Secure using 4 screws (item 4 pg 2) and 4 washers (item 5 pg2).

Caution: Do not over tighten screws.

7. Raise video screen into locked position.

4