8.Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system housing.
9.Raise video system into approximate position and
connect all wiring to components. Route video cable through notch in mounting bracket. Connect wiring and cabling to video system per instructions included with video system.
10.Check function of all components and lights. See operating instructions for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area.
11.Insert video system into opening in console.
Note: Make sure that wires do not get pinched between bosses on video system and console.
Align holes in housing with clips in mounting bracket. See Figure 8.
Secure using (4) four
four 3.5 mm washers (item 5 pg 2). Caution: Do not overtighten screws. FIGURE 8
12.Raise video screen into locked position.
13.Carefully remove (2) two spring clips from rear of O.E.M. console and insert in slots in bracket on console previously installed. See Figure 9.
FIGURE 9
14. Connect wire harness to O.E.M. console and install in original position. Secure front of console using
(1) one # 8 x 1 1/4" screw (item 2 pg 2). Caution: Do not overtighten screws. Make sure clips at rear of console are snapped firmly into tabs on O.E.M. console. See Figure 10.
FIGURE 10
6
