bottom of the opening and check that the speaker matches the shape of the existing
Cutting Speaker Opening
Prepare the speaker opening as follows:
NOTE: This procedure can also be used for any flat panel install (Wagons, Vans, etc.) that have sufficient space behind the panel for recessing the speaker. (The panel must be re- movable or accessible from behind.)
1. Provided that all holes align, place speaker aside and proceed to cut out the oval opening in the fiber panel that covers the existing hole in the steel
NOTE: It is easier to cut the opening if you use a sharp serrated steak knife in a sawing motion. Use care not to
2.Once the speaker openings have been cut, pierce the four speaker mounting holes and enlarge them to a diameter of 3/16”.
Grille Installation
Inspect the grille included with the speaker. If the grille contains existing threaded studs projecting from it , skip this section. If the grille contains four threaded holes in it, locate the threaded rods included with the speaker and screw them firmly into the holes in the grille. The third grille type contains four holes for use with four screws. Proceed with grille installation as follows:
Speaker Cutting Detail
1.Place grille on top of package shelf, allowing the studs to protrude through the holes you previously punched.
2.Place the speaker below the shelf and align it over the four studs of the grille. Secure the speaker using four speed clips included. If the grille requires screws and nuts, insert the screws from the top of the rear deck, and through the grille and speaker; secure grille and speaker with hex nuts.
3.Repeat entire procedure for remaining speaker.
4.Wire speakers per instructions for your stereo system.
