Audiovox ACC-30 installation manual Before Installing The Unit, Transport Lock Screws, l Caution l

BEFORE INSTALLING THE UNIT

Transport Lock Screws

The mechanism in the CD changer is "locked" into place during shipment by the 4 transport screws. Be sure to remove the screws prior to installation.

Retain these screws for future use when transporting the unit for service/maintenance.

l Caution l

After removing the transport lock screws, place the supplied seals over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction.

Installation and Wiring Precautions

1 To prevent a short-circuit,

lBe sure to turn off the ignition and remove the negative (-) battery cable, prior to installation.

lConnect power wires last.

	Note
	If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect
	the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra
	caution during installation, not to cause a short circuit.
2	Do not install the unit in the following locations.
	l Locations exposed to direct sunlight.
	l Where hot air is discharged from the car heater.
	l In areas subject to extreme temperatures.
3	Incorrect installation can cause the sound to "skip" when playing a disc.
	Mount the unit firmly in place, using the supplied brackets and screws.
4	Be careful not to damage the car wiring.
5	l Be sure to use the supplied screws.
	l Be careful not to snag any wires when tightening screws.
	l Do not use any of the screws that are part of the brake or steering system, to install the unit.
6	l This unit cannot be installed on its side, end, or upside down. Installation in such positions will cause malfunctioning
	of the mechanism.

2