PACKING LIST
Main Unit
BEFORE INSTALLING THE UNIT
Transport Lock Screws
The mechanism in the CD changer is "locked" into place during REAR shipment by three transport lock screws. Be sure to remove the screws prior to installation.
CAUTION: After removing the transport lock screws, place the supplied seals (A) over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
lnstallation and Wiring Precautions
BOTTOMFRONT
TRANSPORT LOCK SCREWS (2 RIGHT SIDE,1 LEFT SIDE)
Installation Parts
Bracket(L) | Bracket(R) |
| Hexagonal bolt |
| Screw (C) phillips | ||
|
| with washer (M5 x 10) Head | |||||
|
|
|
|
| (T3 x12) | ||
1pc. | 1pc. |
| 4pcs. |
| 2pcs. | ||
5Meter Din Cable | Seals(A) |
| Seals(B) | ||||
| (T5 x12) |
|
|
|
|
| |
1pc. | 4pcs. |
| 1pc. |
| 1pc. | ||
|
|
|
|
|
|
| |
Other Accessories |
|
|
|
|
|
| |
CD Magazine(P/N 10CD56M) | lndex label sheet | Owner’s Manual | |||||
and lnstallation Guide | |||||||
|
|
|
| ||||
|
|
|
|
|
| ||
|
|
|
|
| OWNER’S MANUAL |
| |
|
|
|
|
| AND |
| |
|
|
|
|
| INSTALLATION GUIDE |
| |
|
|
|
|
| ACC56M |
| |
|
|
|
|
|
| ||
|
|
|
|
|
| ||
1pc. |
| 1pc. |
| 1pc. |
1.To prevent a
●Be sure to turn off the ignition and remove the negative
●Connect power wires last.
NOTE: If the changer is to be installed in a vehicle that is equipped with an
2.Do not install the unit in the following locations.
●Locations exposed to direct sunlight.
●Where hot air is discharged from the car heater.
●In areas subject to extreme temperatures.
3.Incorrect installation can cause the disc to skip when playing.
Be sure to mount the unit firmly in place, using the supplied brackets and screws.
4.● Be sure to use the supplied screws.
●Be careful not to snag any wires when tightening screws.
●Be careful not to damage the vehicle wiring.
5.● This unit cannot be installed on its side, end, or upside down.
Installation in such positions will cause malfunctioning of the mechanism.
2 |
| 3 |
|
|
|