SPECIFICATIONS
Changer
Frequency Response ……………………………………………………… 5 - 20,000 Hz ±1dB
TROUBLESHOOTING
An error made in operation or during installation of this product may be mistaken for a system malfunction. Please perform the checks described below before contacting your dealer or service facility.
Distortion ……………………………………………………………………… 0.008% @ 1kHz
Dynamic Range …………………………………………………………………………… 95 dB
Channel Separation……………………………………………………………… 70 dB @ 1kHz
Wow & Flutter ………………………………………………………… below measurable limits
Dimensions …………………………………………………(W)
(W)250 mm x (H)81 mm x (D)181 mm Operating Voltage ……………………………………………… 12 Volts DC, negative ground
Current Drain …………………………………………… 800mA (Playback/loading/ejecting)
Accessories Supplied: ……………………………………
Mounting hardware (1set)
Connecting cable (1ea.)
Symptom
No power
Magazine cannot be installed
CD is not played
Noise,Skipping,or intermittent sound during playback
Radio will not switch to CDC mode
Possible Cause
Blown fuse
lncorrect connection
Magazine is inserted in wrong direction.
Disc is located incorrectly in magazine
Scratches on disc or warped disc
Extremely dirty disc
Transit screws still in place
Mounting angle adjustment is not correct.
Radio has not been initialized with the ACC56M attached
Remedy
Check fuses in vehicle fuse box and changer system.
Replace as necessary with fuse of same type and rating as original. If fuse blows again, consult with service facility.
Check all wiring and correct as necessary.
Insert magazine in proper direction.
Load disc correctly in the magazine.
Check sound on another disc. If sound from second disc is OK, first disc is defective.
Clean disc
Remove the transit screws from sides of the unit.
Set the mounting angle adjustment to the correct position as per the installation instructions.
Press the RESET button on the face of the radio.
14 |
| 15 |
|
|
|