Audiovox ACC56M Where To Install The Changer, Vertical Installation, 45。ANGLE INSTALLATION

Models: ACC56M

1 10
Download 10 pages 20 Kb
Page 4
Image 4
WHERE TO INSTALL THE CHANGER

WHERE TO INSTALL THE CHANGER

A few of the many mounting possibilities are shown below. The following precautions must be considered when selecting the mounting location.

Installation Cautions and Warnings:

1.Fuel Tank - WARNING! Never install above your fuel tank as the holes you must drill may pierce the tank or the fuel lines. Also check for other obstructions such as wires, etc.

2.Excessive Heat - Avoid areas exposed to direct sunlight.

3.Ease of Use - Make certain the changer is easily accessible for loading and unloading the CD magazine.

4.Distance - The data cable that joins the changer to your existing CDC ready radio is 15 feet long. Do not exceed this length.

5.If mounting to a plastic surface, do not use the self-tapping screws provided. Use the bolts and hex nuts provided for a more secure installation.

IMPORTANT: Failure to properly secure the CD changer is the most common cause of “skipping” and related CD play problems.

Changer must be mounted as explained on the following pages.

INSTALLATION

The ACC56M changer is designed for horizontal (flat), vertical (upright) or 45-degree mounting. It must never be mounted upside-down or on either one of it's sides as explained previously. The position of the built-in anti-vibration springs (left and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective and vibration may cause the disc to skip.

CAUTION: After setting the built-in anti-vibration springs, place the supplied Seals (B) over the holes. These seals are used to keep dust, which could cause a malfunction, out of the unit.

HORZONTAL INSTALLATION Set the 4 anti-vibration springs to positionH

positionH

VERTICAL INSTALLATION

Set the 4 anti-vibration springs to positionV

45ANGLE INSTALLATION

positionV

Set the 4 anti-vibration

 

springs to position45

 

position45

 

4

 

5

 

 

 

Page 4
Image 4
Audiovox ACC56M owner manual Where To Install The Changer, Vertical Installation, 45。ANGLE INSTALLATION