Audiovox ACD-27 Co TIME/FREQUENCY Selector T/F, Cr Mode Selector Mode, Ct THEFT-DETERRENTLED

OPERATING INSTRUCTIONS

10

co TIME/FREQUENCY SELECTOR (T/F)

This unit can display the clock time, radio fre- quency or CD player functions on the display panel. Pressing the Time/Frequency Selec- tor button when the radio frequency or CD player track indication is shown, will change the display to show the time. The time display will automatically return to the radio frequency or CD player function indication after 5 sec- onds.

cp FM MONO/STEREO SELECTOR (MONO) During FM radio operation, this button is used to select mono or stereo reception of the broad- cast signal. Under normal reception conditions, the unit should be left in the stereo mode, as indicated by ST on the display panel when lis- tening to an FM stereo signal. If the stereo sig- nal is too weak for comfortable listening, press the button to switch to mono reception (the ST indication will disappear and MONO appears on the display panel). To return to the stereo reception mode, press the button again so that the ST indication returns.

cq EQUALIZER SELECTOR (EQ)

The EQ button applies preset sound effects to the unit’s audio output signal. The EQ button, when pressed, will activate one of the following operating modes: CLASSICS, POP M, ROCK M, DSP OFF, or FLAT. When the EQ function is active, as displayed (EQ ----CLAS, POP, ROCK)

on the panel, the bass and treble levels can still be changed to accommodate the listener’s ear. However, when the levels are changed, the equalizer function is disabled. When the EQ function is not active, the unit returns to the user- set bass and treble levels. The FLAT selection indicates no equalizer enhancement of the pro- gram, thereby removing the preset sound ef- fects, unless otherwise desired. DSP OFF disables display of the equalizer setting.

cr MODE SELECTOR (MODE)

This button is used to select the radio, or the playback mode for the CD player. Each press

of the button will select a different mode as indicated on the display panel.

During CD player operation, this button may be used to change to radio without ejecting the disc (the CDP indication will remain on the display panel to show that a disc is still loaded in the unit). Press the button again to return to CD player mode.

cs FRONT PANEL RELEASE BUTTON This button is used to release the mecha- nism that holds the front panel to the chassis. To detach the front panel, press the button so that the left side of the panel is released. Grasp the released side and pull it off of the chassis.

To re-attach the panel, position the right side of the panel in place first and then press in the left side of the panel until the mechanism locks it into place.

ct THEFT-DETERRENTLED

The theft-deterrent Light Emitting Diode (LED) is located behind the front panel and is ac- cessible when the front panel is removed. The flashing light serves as a visual warning to the would-be thief that the unit has been disabled by removal of the front panel.

cuRESET BUTTON

A RESET button is located on the front of the chassis (front panel must be removed to access the button). The RESET circuitry is provided to protect the microprocessor cir- cuitry and should only be activated under the following circumstances as it will erase the time and pre-set memories:

1.Upon initial installation after all wiring is completed.

2.If there is a malfunction of any of the switches on the unit, pressing the RESET button may clear the system and return to normal operation.

128-6691

10 of 16